SECTION V: BLOWER
The blower is standard on your vented gas fireplace heater and provides 100 CFM of circulating
air capability – it operates on 115 volts AC, 60 HZ power source and draws 1.5 AMPS. The
blower is attached to the rear of the stove with four (4) screws.
Blower activation is achieved with a temperature switch that mounts to the back of the firebox.
When the back wall of the stove heats up, the blower will activate and when it cools down, the
blower will automatically shut off. The blower will activate at the speed as set on the variable
speed dial.
SECTION VI: OPERATING INSTRUCTIONS
WARNING
Children and adults should be alerted to the hazards of high surface temperatures of the
appliance and should stay away to avoid burns or ignition of clothing. Young children
should be carefully supervised when they are in the same room as the appliance.
CAUTION
•
If the door is removed for service it must be replaced prior to operating this appliance.
•
Clothing or other flammable material should not be placed on or near the appliance.
•
Before operating this heater, please review the safety precautions given earlier in the manual.
•
Check the logs for proper location.
•
Check for gas leaks – soap and water can be used to expose suspected leaks.
•
Verify that the connector pipe and chimney is unobstructed.
•
Be sure the door is properly sealed.
•
When installing the blower, check all connections to avoid electrical shock.
•
Open the gas valve access door to get to the valve; this will also expose the instructions.
FOR YOUR SAFETY READ BEFORE LIGHTING
1. This appliance is equipped with a manual piezoelectric ignition device. Do not try to light the
pilot by hand.
2.
Before lighting
, smell around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
3. Use
only your hand
to turn the gas valve control knob. Never use tools. If the knob will not
turn by hand, do not try to repair it, but call a qualified service technician. Force or attempt to
repair may result in fire or explosion.
4. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system and
any gas valve control that has been under water.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s telephone.
•
Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
WARNING:
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
Summary of Contents for 26-GBVLP
Page 16: ......
