IMPORTANT!
READ AND FOLLOW
ALL
INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
23
ACCESSORY ITEMS
The following accessories can be added to your unit at anytime after purchase; however, let the
unit cool down before adding any accessories.
Thermostat
An external wall thermostat (such as our Part # PU-DTSTAT) can be used on our pellet units, as
long as it is a low-voltage type that works with millivolt systems. After unplugging the unit, locate the
jumper wire (J-18) on the bottom of the control panel. The two screws should then be loosened and
the jumper wire removed from the board. Next, the two thermostat lead wires should be slipped into
these openings and the screws tightened; the jumper wire should be saved for future operation
without a thermostat.
The unit will operate differently once the wall thermostat is connected – we recommend the
Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to
the section on “Start-up Procedure” for information on cold starts.
AC-103, AC-103BN Lip Trim
There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the stove.
Match the channel with the correct edge of the ash apron, then remove the protective covering from
the trim and force the piece onto the edge. Although it should stay in place, stove cement can be
used to secure it if necessary.
AC-106-P, AC-106-PBN Window Trim
Window trim can be attached by using the provided spring clip(s) and some high temperature
silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim – then,
turn the clip and set the other end of the clip into the channel. The spring clip will hold well if it is
placed on the top edge of the trim before placing the trim in the window of the stove. Place the top
edge with the clip into the window opening, then push the bottom edge of the trim flush with the
window. We also suggest that high temperature silicone be used on the corners, to ensure the trim
will stay in place.
Accessories can be ordered from the factory at:
(Parts orders ONLY) -- (800) 516-3636, or on our web site:
www.englanderstoves.com
.
Questions/Problems
: Please call Technical Support at (800) 245-6489.
You may also order parts and options, view frequently asked questions and more,
on our web site:
www.englanderstoves.com
Summary of Contents for 25-PDVC
Page 30: ......
