V084012-F October 07
Kohler Co.
-3-
Move 45º Corner Posts and
Return Panel Assemblies out
to allow Door Assembly to be
fitted.
5.
Fit Door Assembly into 45º
Corner Posts and push
together.
6.
Using a sharp knife, trim top
seal off door as shown.
9.
Centralise Door Assembly
between Wall Retainer and
Corner Post.
b.
Position Return Panel between
Wall Retainer and Corner Post so
that the black lines at each corner
are not visible.
DO NOT push the
PVC gasket into position at this
stage.
Ensure an even gap between
Door/Returns and edges of the
tray.
7a.
Check that the Door and
Return Panel Assemblies are
level with top of Wall Retainer and
45º Corner Profiles.
8.
IMPORTANT
TEST THE OPENING AND
CLOSING OPERATION OF THE
PIVOT DOOR
Using spirit level, plumb
Door, Return panels and
45
O
Corner Posts. Tape into posi-
tion as shown. Check Door opens
and shuts properly and the black
lines on the Return assembly top
and bottom rails remain hidden.
Readjust if necessary.
NOTE: This is an important part
of the installation procedure
and your careful attention at
this stage will ensure that you
will obtain the best possible
results.
10.
If door alignment is incorrect,
door will not function properly
and further adjustments are
necessary. Remove tape and re-
align until correct alignment is
achieved.
