Enhanced Mobility Systems RollerAid FFOTS, Safety Instructions & Operator'S Manual

For OTS Set Up, see page 14 

Instructions for straightening the handlebar folding assembly, 

adjusting the basket or handlebar, and attaching the basket 

begin on Page 14 of this Safety and Use Manual. 

UNFOLDING the RollerAid

™ FFOTS

Unfolding and se

tting up the RollerAid™ FFOTS for the first time is 

simple and easy. 

1.

Remove the unit from its box and lay it out on a stable surface. 

2.

Undo the Velcro™ tie and straighten the hinged 

assembly as 

shown below.  Wrap the Velcro

™

 loosely around the crossbar so 

that it does not get trapped under the rear wheels. 

Note:

  If the hinge assembly appears tight open the bench quick release, 

raise the bench up slightly and retighten the quick release. 

3.

With the hinge assembly quick release in the position shown, lift 

the locking pin until you can see it at the top of the hinge 

assembly and rotate it towards the front of the unit using the 

quick release lever. 

        11 

4.

Lock the quick release by rotating it to the vertical position as 

shown below.  Position the brake cables on either side of the 

bench post and above the quick release. 

The hinge assembly should now be locked firmly in place. 

12 

1  Lift locking pin 

2  Rotate lever toward 

front of unit 

Rotate lever down 

to lock in position 

Roller Air Manual Complete.indd   11

5/20/08   3:37:47 PM