ACROBAT HD SETUP
1. Unpacking and transporting the
Acrobat HD
During unpacking and transporting, be sure to lift
the Acrobat HD by the built-in carrying handle.
Do not attempt to lift or carry the LCD by the
base. (See Figure 1)
2. Setup the Acrobat HD
Place the Acrobat HD on a flat, level surface such
as a table or desk.
3. Connect the AC power
Connect the attached power cord to an
available wall outlet. (See Figure 2) To offer
additional protection during an electrical storm,
a surge protector may also be used and is
recommended.
4. Turn the power on
On the rear, right side of the Acrobat HD, flip the
switch from the 0 to l position (See Figure 3). The
LCD screen and Acrobat HD Camera will
automatically
turn
ON
in
a
few
seconds.
An
image
of what the Camera is pointing at should appear
on the LCD screen.
Turn the power OFF by flipping the same switch
back to the 0 position. However, leave the power
ON
for
this
training
section.
Once the Acrobat HD has been powered on you
can then use the Red
“Power” button located in
the upper right corner of the Acrobat HD Remote
to power the Acrobat HD on/off.
Figure 1
Figure 2
Figure 3
Acrobat HD Setup
11
Summary of Contents for acrobat HD
Page 1: ... Users Manual ...
Page 10: ...2 1 4 7 8 3 5 9 6 10 11 10 Acrobat HD Package Contents ...
Page 38: ...NOTES Notes ...
Page 39: ...Notes NOTES ...
