24
Recharging the Battery
The battery recharges in the LCD Power Pack. All you need to do is plug
in the desktop power supply to the LCD Power Pack and the wall and the
battery will automatically start charging. Refer to page 23. If the light is
solid then the battery is fully charged. If the light is blinking then the battery
is not fully charged. The battery will charge while in use as long as the
system is plugged into a wall. The battery will charge at the same rate
whether the LCD Power Pack is ON or OFF. You cannot overcharge the
battery. The battery has no memory so you can charge it at any time.
However, the more charge cycles, the shorter the battery life. Maximum
charge time is 4 hours.
Removing and inserting Battery from lcD power pack
It is recommended to always keep a battery in the LCD Power Pack. The
only reason you need to take the battery out is when you are changing bat-
teries.
To remove the battery, push down on the “RELEASE” button on the front
top right of the LCD Power Pack. See Figure 1. The battery should
release from the LCD Power Pack so you can slide it out.
To insert the battery, gently insert the battery, label facing up, into the base
of the LCD Power Pack. Make sure the battery is fully inserted. You
should hear a click. See Figure 2.
Figure 1
Figure 2
Flipper Stand
™
u
Sing
lCD p
ower
p
aCk
