31
30
Flipper:
Q. Reading with Flipper on top of the literature is difficult. is
there other method i can use for reading?
A. Another method for reading with Flipper is to place the reading material
on an upright bookstand. This method allows the camera to be pointed
directly forward at the reading material. The camera can then be rolled
left to right to scan the reading material. Refer to page 13.
Q. the image appears dim on my television. How can i adjust
the images brightness or contrast?
A. There are no external adjustments on our products. However changes
can be made through an adjustment menu or external button on your tele-
vision. Please consult your television’s manufacturer user manual for
additional information.
Q. i have my product connected properly, but i’m still not see-
ing an image. What am i doing wrong?
A. If your system is connected to the television’s “video in” port, check to
see that your television is on the proper “video” mode, usually located on
your remote control or your television’s menu options.
Some remote controls access this channel by pressing a TV/Video, Input,
auxiliary (AUX), External (EXT), Game, or source. (Please note this chan-
nel differs depending on the television maker. Please consult your televi-
sion manufacturer’s user manual for additional information).
Flipperpanel:
Q. How long will the battery last?
A. The battery will last approximately 3 - 4 hours per complete charge.
Q. How long does it take for the battery to recharge?
A. The battery needs a minimum of 4 hours to recharge.
Q. How does the battery recharge?
A. There is no separate battery charger included with the FlipperPanel.
Keep the battery inserted into the panel. Connect the Desktop Power
Supply to the FlipperPanel and plug it into the wall power source. The
battery will recharge while in the panel. The battery will also continue to
charge if the panel is in use.
Q. can i use the Flipperpanel without the battery?
A. Yes. The FlipperPanel comes with a Power Supply that can be
connected to an AC wall outlet or power strip. Doing this will run the
FlipperPanel and also recharge to battery at the same time. (please note
the system will also operate in case where no battery is inserted and the
wall adapter is used.)
Q. Does the battery have to be completely discharged before i
recharge it?
A. No. The FlipperPanel has a lithium ion battery that does not need to be
completely discharged before recharging it again. The battery cannot be
over charged. However, the fewer the charging cycles, the longer the bat-
tery life.
coMMon QUeStionS
C
ommon
Q
ueStionS
C
ommon
Q
ueStionS
