CCTV DOCKING STAND
The CCTV Docking station can function as a full featured
desktop CCTV when purchased as an optional accessory.
CCTV Setup:
Place the CCTV docking station securely on your desk or table.
First you will want to power your docking station. Connect the
power cord to the power supply (See Figure 1 Power Supply).
Connect the power cord to an available electrical outlet (See
Figure 2 Connecting to an Outlet). Connect the other end of
the power supply to the rear of the MoJo Docking Station where
it is labe
led “19VDC” (Also Shown Figure 3 Rear Panel
Connections). To offer additional protection during an electrical
storm, a surge protector may also be used and is
recommended.
Removing the MoJo Lanyard:
In order to place the MoJo into the CCTV Docking Stand you
must first remove the Lanyard. Locate the Mojo Lanyard Clip as
Shown in Figure 4. Then lightly pinch the clip tabs until they
come apart with ease and fully remove the clip.
CCTV Docking Station
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
21
