23
Chapter 6
Charging & Using Battery
To charge the battery inside your Pebble-mini, simply connect the
included AC adaptor as described on the bottom of
page 10
.
• If the battery is completely drained, the Pebble-mini will not turn
on while charging. Connect the unit to the AC adaptor for 15
minutes prior to turning on the Pebble-mini.
• If the Pebble-mini battery is not completely drained, then you can
continue to use your Pebble-mini while it is being charged using the
AC adaptor and USB cable.
• When the Pebble-mini is plugged into a computer using the USB
cable, the unit will charge but cannot be used at this time. Your
Pebble-mini takes approximately 3.5 hours to fully charge. A fully
charged battery should give you approximately 2 to 3 hours battery
life depending on the brightness level.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Battery Charging Procedure
Figure 1
Figure 2
Replacing the Battery
1) Locate the battery compartment door
.
(See Figure 1)
2) Using your fingernail, press the latch
to the bottom as shown in
Figure 1
by
the arrow.
(See Figure 1)
3) Open battery door and remove the
battery.
(See Figure 2)
4) Insert new battery. Press and hold
latch to the bottom and swing the door
back until snapped close. Release the
latch to lock battery door shut.
