IRONING
•
To dispense steam, press the button (15) on the iron; when the button is released, steam
dispensing is interrupted.
•
To use the continuous steam function, press the button (15) and simultaneously push the slider
(16) towards the cork handle of the iron. To disable this function, move the slider (16) in the
direction away from the handle.
•
By placing the iron vertically at a distance of about 20 cm, you can dispense steam to revive
and refreshen fabrics.
•
With the steam adjustment knob (6), you can set the amount of steam to use while ironing: for
more steam, turn the knob clockwise, for less steam, turn the knob counter-clockwise
•
Do not this while you are wearing the garment because the steam is very hot and can cause
burns.
•
Before ironing delicate fabrics, we recommend that you test a hidden spot on the garment, such
as a hem.
•
We recommend that you start ironing more delicate fabrics, which require lower temperatures,
first and then iron more resistant fabrics that require higher temperatures.
ATTENTION!
When you start dispensing steam, a few drops of water may leak from the plate (14) of
the iron; this is completely normal and is due to condensation that may form inside the
hose connecting the iron to the boiler (10).
The water will disappear as you continue dispensing steam.
We recommend that you avoid pointing the first steam jet towards the fabric to be ironed.
The iron must be used and rested on a stable surface.
Be careful never to direct the steam towards persons or animals
NO WATER DURING OPERATION
•
The lack of water in the boiler is indicated by the indicator light (5).
•
To add water to the boiler, proceed as follows:
- Turn the selector knob (2) to the iron only position to turn off the boiler.
- Press the button (15) on the iron until no more steam is dispensed;
- Turn the knob (2) to OFF to turn off the appliance and remove the plug from the wall outlet.
- Remove the plug from the outlet; Wait for the boiler to cool down before opening the tank
- Unscrew the boiler cap (7) very slowly paying attention to any remaining steam;
- Fill the boiler by following the same instructions in the section “HOW TO FILL THE
BOILER WITH WATER”;
- Put the appliance back into operation by following the instructions provided in the
“OPERATION” section.
ATTENTION!
Always disconnect the plug from the wall outlet before filling the boiler with water.
DANGER! It is important to depressurise the boiler by pressing the button (15) on the iron until
the steam is all released;!
AFTER IRONING
•
Turn the selector knob (2) to the iron only position to turn off the boiler.
•
Press the button (15) on the iron to release all residual steam. Turn the knob (2) to OFF to turn
off the appliance and remove the plug from the wall outlet.
•
Remove the plug from the outlet.
•
Press the button (12) to automatically wind up the power cord in its seat: when you do this, we
recommend that you guide the power cord with your hand while it is rewinding. If the power
cord is not completely wound, pull it out again and repeat the operation.
•
Rest the iron on the base (8) and wait for the appliance to cool down before doing anything
else to it.
7
