40
EN
The motor slows down:
•
Check whether the device is overloaded by
the workpiece.
•
Reduce the pressure applied on the
workpiece.
•
Check whether the workpiece is suitable for
the tasks to be carried out.
The cutting disc experiences difficulties
penetrating the material to be processed or
the cutting performance is insufficient:
•
Check whether the chosen cutting disc is
suitable for the material to be processed.
•
If the cutting disc is worn, replace it with a
new one.
The device becomes hot:
•
Check whether the cutting disc is suitable
for the tasks to be carried out.
•
Make sure not to exert too much pressure
on the device during operation.
•
Keep the venting slots clear to prevent the
motor from overheating.
•
Wait for 10 minutes before switching the
device back on.
Notice
Wait for at least 3 minutes after maintenance
and repair work. Only then switch the device
back on.
Your device still does not operate correctly
after these checks?
Please contact the customer service. If
necessary, bring the device to an authorized
specialist electrical company or to Eurospin for
repair.
9. Maintenance
Activities required before starting
maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with
wet or damp hands.
•
Switch off the device.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the
housing to be opened must only be carried
out by authorised specialist companies or by
Eurospin.
Notes on maintenance
Inside the device, there are no parts that need to
be maintained or lubricated by the user.
Cleaning
The device should be cleaned before and after
each use.
Notice
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories
in water. Make sure that no water or other
liquids can enter the housing.
•
Clean the device with a soft, damp and lint-
free cloth. Ensure that no moisture enters
the housing. Protect electrical components
from moisture. Do not use any aggressive
cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive
cleaners to dampen the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Remove dust from inside the guard, from
the mounting flange and from the clamping
nut.
•
Keep the connecting terminals on the
device and charger clean.
•
Keep the connecting terminals on the
battery pack clean.
•
Keep the ventilation openings free from
dust deposits to prevent overheating of the
motor.
•
For maintenance of the cutting disc, see
chapter Tool change.
