36
EN
•
Check the quick charger for damages.
Should the quick charger be damaged, stop
using it. Contact the EUROSPIN customer
service.
•
Check the battery terminals for dirt. Remove
any dirt.
•
The battery might be defective and have to
be replaced. Only use batteries of the same
type.
The device does not start:
•
The battery power might be too low.
Recharge the battery.
•
Check whether the battery is correctly
connected to the device.
Slide the battery onto the device in a way
that the battery terminals engage. The
battery must lock in place in the device.
•
Check the battery terminals for dirt. Remove
any dirt.
Info
Wait for at least 10 minutes before switching
the device back on.
The saw blade is loose:
•
Make sure that the saw blade is firmly
locked in place in the designated recesses
of the quick-release chuck.
•
Make sure that the quick-release chuck is
locked.
The saw blade experiences difficulties
penetrating the material to be processed or
the sawing performance is insufficient:
•
Check whether the pendulum action setting
is suitable for the material to be processed.
•
If the saw blade is worn, replace it with a
new one.
•
Check whether the chosen saw blade is
suitable for the material to be processed.
The device becomes hot:
•
Make sure not to exert too much pressure
on the device during sawing.
•
Check whether the chosen saw blade is
suitable for the task to be carried out.
•
Keep the venting slots clear to prevent the
motor from overheating.
Info
Wait for at least 10 minutes before switching
the device back on.
Note
Wait for at least 3 minutes after maintenance
and repair work. Only then switch the device
back on.
Your device still does not operate correctly
after these checks?
Please contact the customer service. If
necessary, bring the device to an authorized
specialist electrical company or to EUROSPIN
for repair.
9. Maintenance
Activities required before starting
maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with
wet or damp hands.
•
Switch off the device.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing
to be opened must only be carried out by
authorised specialist companies or by
EUROSPIN.
Notes on maintenance
Inside the device, there are no parts that need
to be maintained or lubricated by the user.
Cleaning
The device should be cleaned before and after
each use.
