EN
20
3. Before use
WARNINGS
Always disconnected with the plug from the
mains socket before assembling. Danger of
electric shock.
Unpacking
1. Unpack all parts and lay them on a flat
stable surface.
2. Make sure the delivery contents are
complete and free of damage. If you find
that parts are missing or show damage,
do not use the product but contact your
dealer or the service center. Do not use the
product unless missing parts have been
delivered in addition or defective parts
have been replaced. Using an incomplete or
damaged product represents a hazard to
people and property.
3. Ensure that you have all the accessories
needed for assembly and operation.
Preparation
1. Before connecting the compressor to the
mains supply, make sure that the data on
the rating plate are identical with the main
data.
2. Install the compressor near the point of
consumption.
3. Avoid long air lines and supply lines
(extension cable)
4. Do not install the compressor in a damp or
wet room.
5. The compressor may only be used in
suitable rooms with good ventilation and
an ambient temperature from +5ºC to
40ºC. there must be no dust, acids, vapors,
explosive gases or inflammable gases in
the room
6. The compressor is designed to be used
in dry rooms. It is prohibited to use
the compressor in areas where work is
conducted with sprayed water.
7. The oil level in the compressor pump has to
be checked before putting the compressor
into operation.
8. You will require Open-ended wrench
which are not supplied in the package for
assembly before using it for the first time.
9. Before first use install the air filter and fill
with the supplied oil to the middle of the oil
level indicator.
Attaching the supporting feet (fig. B)
Use the supplied mounting materials, nut (22),
flat washer (23), screw (24) and supporting
foot (9) to fit the two supporting feet.
Assembling the wheels (fig. C)
Use the supplied mounting materials, flange
screws (20), spring washer (21), nut (22) and
two wheels (11) to fit the two wheels.
Mounting the air filter (Fig. D)
Screw the air filter (14) to the compressor.
Filling the oil (Fig. E)
1. Remove the transportation lid (25) of the
oil filling opening (19).
2. Filling the supplied compressor oil into the
crank housing and insert the included oil
sealing plug (15) into the oil filling opening
(19).
Fitting the compressed air hose
NOTE: the air hose is not in the package, need
prepare it by yourself.
Use the compressed air hose if you intend
to carry out work at a greater distance from
the compressor. Connect the nipple of the
compressed air hose to one of the quick-lock
coupling (3 or 7). Then attach the compressed
air tool to the quick-lock coupling on the
compressed air hose.
4. Operation
WARNINGS
1. Make sure that the power supply voltage
matches the voltage rating indicated on
the rating label.
2. Ensure that you have sufficient space
in which to work and that you do not
endanger other people.
