The Critical Component
EN Series User Manual
27
PDU
The list of connected PDUs will be displayed as folders in the dashboard. Each PDU folder contains the following
contents:
•
pdu1
•
Input Phases
•
Circuit Breakers
•
External Sensors
•
Outlet Power Management (
not available for EN1000 & EN2000 models
)
Each content item can be viewed, managed, and edited from this section.
PDU
The PDU page displays the following attributes of the PDU. These can all be edited by selecting the “Value” cell
of each category setting.
•
PDU Settings
: PDU name, PDU location, PDU Coldstart Delay, Outlet State on Startup
•
PDU Energy
: Reset Energy, Reset Outlet Energy
•
PDU Attribute
: MAC Address, Rating, Resettable Energy Meter, Active Power Value, Active Power Status
Input Phases
Editing Input Phase Settings
To change the Input Phase settings and alarm notifications,
1. Select Status, Setting link.
Note: this link is “Normal” by default.
2. In the Input Phase Current Phase Alarm Setting dialog boxes, change the fields as needed:
•
Lower Critical (A)
•
Lower Warning (A)
•
Upper Warning (A)
•
Upper Critical (A)
•
Reset Threshold (A)
•
Alarm State Change Delay (samples)
3. Select Save when finished.
Circuit Breakers
Viewing Circuit Breaker Data
Some models of Enlogic PDUs have two circuit breakers, others have six circuit breakers, and customized
models may have any number. To view details about each circuit breaker on the PDU click “Circuit Breakers” on
the PDU Explorer to open the Circuit Breakers Data Panel. If a circuit breaker is tripped, an alarm will be displayed
on the dashboard and on the Status setting of the Circuit Breakers Data Panel.
Note: this does not apply to EN1000
and EZ1000 models.
The below information will be displayed for each circuit breaker on the Circuit Breakers Data Panel:
•
Circuit ID: given automatically by the system.
•
Status, Setting:
•
Current, RMS (A): RMS current in amps
•
Rating (A): The circuits amp rating. This information is also found in the System Administration > De
-
vice Information > Circuit Breakers tab.
•
Remaning Capacity (A) = Rating(A) minus Current, RMS (A)
•
Input Phases: Indicates the input phase the circuit breaker is on. L1 indicates that the circuit breaker
is on input line 1.
•
Connected Outlets: Indicates the outlets that are connected to each individual circuit breaker. These
cannot be edited.
Setting Circuit Breaker Alarms
The EN Series PDU will send alert notifications when a circuit breaker amperage crosses above or below the
settings you specify in the Circuit Breaker Alarms configuration: