www.enlogic.com
6
Section 1: Introduction
This manual is intended to assist in the installation and setup the EN Series PDU. Refer to this manual to properly install and
operate the EN Series PDU. It is recommended that the user follows the procedures as outlined in this manual to assist in proper
installation and prevent damage to the PDU and associated equipment.
The Enlogic family of enterprise-grade rack PDUs includes comprehensive power management, watt-hour energy metering, and
environmental monitoring; all within the industry’s slimmest space-saving design. A large selection of standard and configurable
PDU options are available to meet your specific rack management application.
Enlogic Product Series
Product Series Type
Description
EN1000 Series
Metered
Metered PDUs with real time metering and network monitoring of power loads for
overload avoidance, capacity & load balancing, and energy use optimization.
EN2000 Series
Metered and Outlet
Switched
Remote outlet on/off switching for power-up sequencing, remote power cycling, and
outlet use management combined with all features of the EN1000 Series.
EN5000 Series
Outlet Metered
These outlet metered PDUs combine Individual outlet power and energy metering
with all features of the EN1000 Series.
EN6000 Series
Outlet Metered and
Outlet Switched
Comprehensive management solution includes switching features of the EN2000
Series and outlet metering features of the EN5000 Series.
EZ1000 Series
Inline Energy Meters
This energy metering device adds the Enlogic EN1000 series capabilities to any exist
-
ing basic PDU or stand-alone equipment.
Product Components
Enlogic PDUs include the following components in various configurations:
•
Input power cord
•
Outlets
•
Connection ports
•
OLED display
•
Reset button
•
Circuit Breakers (some models)
Input Power Cord
Most PDUs come with a power cord installed and ready to be plugged into an appropriate receptacle. Connect
the PDU to an appropriately rated branch circuit. Refer to the label on the PDU for appropriate input ratings and
ranges.
Input Power Cord Orientation
The Input Power Cord is factory set at the top of the PDU. This can be rewired to allow for a front-oriented power
cord.
DANGER
When rewiring the Input Power Cord, only use the wires
provided with Enlogic PDUs. Use of other wires is prohibited.
Rewiring must be completed by authorized service providers.