EX-5100 C
OMBUSTIBLE
ENMET
1
1.0 Introduction
The
ENMET EX-5100
sensor/transmitters (S/T) is, 3-wire, 24
V
DC
4-20 ma S/T for the detection of combustible gas. The
EX-
5100
is meant to be used in conjunction with an appropriate power supply and controller. The
ENMET EX-5100
sensor/transmitter is in an enclosure rated for use in a Class I, Div. 1, Groups B, C, D, classified area.
N
OTE
:
All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the
EX
-
5100
and examine it for shipping damage. If such damage is observed, notify both
ENMET
customer service
personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N
OTE
:
It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in
good condition.
When it was picked up by the carrier at
ENMET
, it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET
Customer Service for return authorization and further instructions. Have your Purchase Order and Sales
Order numbers available.
ENMET
either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage,
usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage.
ENMET
only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a written
request to
ENMET
Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify
ENMET
Customer Service within 5 days of
receipt at the following address:
ENMET
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the
EX-5100
is received as ordered. [Each
EX-
5100
is labeled with its target gas.] If there are accessories on the order, ascertain that they are present. Check the contents of
calibration kits. Notify
ENMET
customer service personnel of any discrepancy immediately.
1.3 Serial Numbers
Each
EX-5100
is serialized. These numbers are on tags on the equipment and are on record in an
ENMET
database.
