Code: I.H4.V10.3003
Installation and Maintenance Manual
Version: 07
16 / 66
Ennera Energy and Mobility, S.L.
This document contains confidential information which is property of Ennera Energy and Mobility, S.L. The copy, transmission or use by other people, of the whole document or
part of its contents, is not allowed without written permission from Ennera Energy and Mobility S.L.
13.
Adjust both sections until inter-
ference distance mark is reached by the
fourth section (follow step 9).
14.
Before connecting the fifth section,
make the anemometer assembly.
See section 5.5.
15.
To connect the fourth and fifth
sections, align the welding spot in both
sides of the flange.
16.
Fix the fourth and fifth sections by
means of a flange:
•
Pass the cable guide through the
fifth section.
•
Using a screw as a guide, fit
manually the fourth and fifth
sections.
•
Fix them with allen M12x50 screws,
washers and nuts.
•
Apply Loctite 243 adhesive and tight
them with a torque of 90 Nm.
Allen screw
Plain washer
Plain washer
Grower washer
Nut