Code: I.H4.V10.3003
Installation and Maintenance Manual
Version: 07
20 / 66
Ennera Energy and Mobility, S.L.
This document contains confidential information which is property of Ennera Energy and Mobility, S.L. The copy, transmission or use by other people, of the whole document or
part of its contents, is not allowed without written permission from Ennera Energy and Mobility S.L.
14.
Take the other tip of the elevation
cable (W17) (previously fixed to the
fourth section) and attach it to the
eyebolt of the ginpole with a shackle.
Check alignment of the
ginpole and the tower in
the lifting direction.
15.
Once everything is connected,
continue lifting up the ginpole with the
tractel.
16.
After the ginpole (EL-6) is in vertical
position, keep working with the tractel
(EL-3) until the tower is in vertical
position.
17.
Level the nuts and washers to the
position where the tower is vertical.
18.
Once the lift-up test is performed,
lift the tower down to its resting
position.
