Code: I.H4.V10.3003
Installation and Maintenance Manual
Version: 07
24 / 66
Ennera Energy and Mobility, S.L.
This document contains confidential information which is property of Ennera Energy and Mobility, S.L. The copy, transmission or use by other people, of the whole document or
part of its contents, is not allowed without written permission from Ennera Energy and Mobility S.L.
3.
Fix the generator (W1) and the yaw
(W6) using M10x55 screws and DIN
9021 wide plain washers.
•
Tight them with a torque of 50 Nm.
4.
Put yaw cover (W12) in the yaw
(W6) - generator (W1) union and fix it
with two M4x16 countersunk allen
screws and four M6x20 allen screws.
5.7.4.
Rotor
1.
Put the generator facing up:
•
Lift up, just a bit, the tower in order
to rotate the generator to the
correct position.
•
Rotate generator to put it facing up
as shown in the figure.
•
Keep holding the generator and lift
down the tower until it rests
properly in a base.
2.
Fit the bushing (W10) to the hub
(W9) with a nº 50 spanner.
Check that the bushing is
fully tightened and the flat
surfaces are in contact.
3.
Place the hub on the generator
shaft.
W12
W9
W10
Grower washer
Wide plain washer