Code: I.H4.V10.3003
Installation and Maintenance Manual
Version: 07
31 / 66
Ennera Energy and Mobility, S.L.
This document contains confidential information which is property of Ennera Energy and Mobility, S.L. The copy, transmission or use by other people, of the whole document or
part of its contents, is not allowed without written permission from Ennera Energy and Mobility S.L.
15.
Place nameplate sticker in the
housing front door (inside).
5.8.3.
Electrical scheme
Some advices must be taken into account when making the electrical installation. The earth for
the wind turbine and converter must be a local ground, which is located into the foundation. Both
wind turbine and converter must be connected to this grounding point.
The grid protection equipment must be located always between the Windera S converter and
the grid connection point.
Never install a circuit breaker between the Windera S converter and the wind turbine.
The installer must calculate the wire section for the cable between the Windera S converter and
the grid connection point.
As general recommendation:
Distance
Section
Up to 50m
6 mm
2
From 50m to 100m
10 mm
2
For more information, check the Single Line Diagram in Annex 2.
5.8.4.
Anemometer
The anemometer type that can be connected to the Windera S converter is one with frequency
output proportional to wind speed. The power supply should be 12V-15V and the maximum current
300 mA.