26 CT81900001 Rev.01 – 07/13
There is a current interruption on the
controls.
Ad just the thermoregulator as come
shown in chapter n°13.
The compressor does not work.
Check the condition of the.
compressor. If necessari contact a
qualified technician to replace it with
another one of the same type.
The machine
temperature is
Not colde nough.
The thermoregulator is not correctly set.
Ad just the thermoregulator as come
shown in chapter n°13.
The machine is installed near a
heat
source.
Move the machine a way from the heat
source as described in chapter n°12.
The machine ispositione dless than 15cm
away from surrounding obstacles.
Move the machine away from the
surrounding obstacles,as shown in
Chapter12.
The air circulation via the ventilation
apertures is obstructed.
Free the ventilation apertures.
There is an interruption in the refrigeration
circuitor there is
no gas.
Contact a qualified technician to check
that the gas expansion
temperature.
The machine
temperature is
too
cold.
The thermoregulat or is not set
to the
correct position.
Ad just the thermoregulator as come
shown in chapter n°13.
Ice on the innner
backside
The door has been kept open for a long
time or the inside temperature is too low.
. Check the hermetic lock of the door.
Increase automatic defrosting. Set
manual defrosting.
Set thermoregulator as indicated in
chapter 13.
Water on the bottom
of the machine.
The defrosting water outlet is clogged.
Check that there are no impurities
on
the drainer.
The lighting or
ventilation do
not
work..
The machine is not plugged into the
current socket.
Plug the machine in correctly.
The power supplì cable is damaged or
interrupted.
Check the condition of the.
compressor. If necessari contact a
qualified technician to replace it with
another one of the same type.
The mains bipolar switch is off.
Turn the mains bipolar switch on.
Power failure on controls.
Check the condition of the controls If
necessary,contact a qualified
technician
to restore the current.
The light or ventilations witch
is off.
Turn the light or ventilations witch
on.
Light is damaged or interrupted.
Check the condition of the.
lighting. If necessari contact a qualified
technician to replace it with another one
of the same type.
The
displayed
temperature is not in
conformity with the
real one.
The probe is not properly set.
Set probe 1.
