eno
one 2/r - user manual
REV.05
18
Before insertion into the bottle ensure the correct length of the straw. Place the
straw next to the bottle to be inserted. The recommended length of the straw must
be at least 2 cm (0.79 in) higher than the length of the bottle and
never more than 5 cm (1.97 in).
If the straw is longer, cut it using a pair of scissors.
A straw that is too long could bend inside the bottle
limiting the passage of the liquid possibly resulting in its complete obstruction.
If the length is less than that suggested, replace the straw with one that is ade-
quate.
An overly short straw will not allow dispensing of all the liquid
inside the bottle.
Always replace straws that are deteriorated from use. (e.g. torn, deformed).
Further straws can be obtained from the retailer Enomatic.
18. RUBBER STRAW MEASUREMENT
no.3 rubber straws are supplied, necessary to remove the wine from the inside of
the bottle and to convey it to the plug tap (
N
) of the
Dispenser unit. The end of the straw where the filter that restricts the passage of
wine sediments is located must be inserted into the bottle while the other end must
be connected to the plug tap.
2÷5 cm
0.79÷1.97 in
>5 cm
>1.97 in
19. FUNCTIONS MENU
The Dispenser has a menu with features that are useful to set the main parameters
and in order to interact with it. To access the Functions menu press the multifunc-
tion button
(Z)
for 3 seconds and release it as soon as the letters "F1" are displayed.
Scroll with the arrow buttons (
X
,
Y
) to select the desired setting
and then press the multifunction button (
Z
) once.
to access the specific function. The operation described above must be carried out
within a few seconds otherwise the Dispenser will automatically trigger the
time-out
mode,
returning to the previous menu without having stored any function/parameter.
Below is shown the correspondence of the functions to the related acronyms dis-
played on the lit display (
W
):
F.1
BOTTLE INSERTION
F.2
TEMPERATURE SCALE SETTING
F.3
DOSE MODE SETTING
F.4
DOSE PROGRAMMING
F.5
LED INTENSITY SETTING
F.6
WASHING AND SANITISING
F.7
DISPENSER VERSION
USE AND OPERATION
