eno
one 2/r - user manual
REV.05
30
26. F. 4 TYPES OF PROGRAMMED DOSES
[dF default setting]
In addition to the default settings "PO" (para. 25), the programmed doses can also
be recorded as chosen by the user in the following ways:
Copy "CO"
allows the storing of 3 doses different from each other (small, medium
and large) on one of the two dispensing units and to then copy them automatically
onto the adjacent one (para. 28).
Not Copy “nC”
allows to store 3 doses different from each other (small, medium
and large) and completely different between one dispensing unit and the other
(para. 29).
Copy All “CA”
allows the storing of one unique dose from the medium dose but-
ton
(V2)
on one of the two dispensing units and to then copy it automatically onto
the adjacent one (para. 30).
In order to reset the default settings
Default “dF”
follow the instructions shown in para. 27.
USE AND OPERATION
It is advisable to perform programming of the doses with a bottle of water in
order to avoid wasting the wine. In this case, the doses of wine may not cor-
respond exactly to the doses pre-set with water, given the different densities
and temperature between the two liquids.
Before proceeding to programming of the doses there-
fore, fill a 0.750 l (26.4
fl.oz)
wine bottle with drinking
water (2 bottles are only required in the “Not Copy”
“nC” case) to set/change the doses.
Insert the bottles of water following the bottle insertion
procedure (para. 20) and dispense, again just the once,
the large dose (
V3
).
Dispensing after insertion is essential in order to fill the
ducts of the dispensing unit for precise storage of the
dose.
To measure the desired quantity it is recommended to
use a graduated cylinder, sold by Enomatic reteiler.
