- 13 -
3.2 Stop Charging
In charging state before the EV is fully charged, the user can stop charging by press the Stop button. When the
EV is fully charged, the charging will stop and the screen will display End status, then the charging gun can
be pulled out directly. When the voltage drops below 50V, the charging session will end, and the user can pull
the gun out.
3.3 Button Setting
There are four push buttons on the charger interface, which are used to set relative parameters such as: current
limit, module voltage/current, module voltage/current etc.
1)
“ESC”: In charging mode, it is for “Stop”, press it then the charging will end. In setting mode, it is for
“Back”, press it to return to last step.
2)
“
△
”: In setting mode, press it to move upwards or increase the value.
3)
“
▽
”: In setting mode, press it to move downwards or decrease value.
4)
“OK”: It is for “Enter”, press it then you can enter the menu for different settings.
