ENSA SSL-B Solar Street Light Installation Manual - Version: ENSASSLB-Q219
12
Power
Press to power on. Press and hold for 2 seconds, then
release to power off the remote control.
Scroll Up
Press to scroll up.
Scroll Down
Press to scroll down.
Controller On
Press and hold to enable the LED light control.
Controller Off
Press and hold to disable the LED light control.
Enter
Press to select item or confirm changes.
Back
Press to select item or confirm changes.
Transmit
Press to transmit parameters to the control board.
Test
Press to test the LED light.
4.3 Remote Control (continued)
4.
Point the remote control at the solar panel’s black sensor and scroll to the SysConfig (System
Configure) and press
(Enter) to enter the system configuration menu.
•
Use
and
to scroll.
•
Press
Enter
to begin editing values. The value will be shown in reverse colour.
•
Use
and
to change the value.
•
Press
Enter
again to confirm.
Note:
The remote will power off automatically if no key is pressed for 3 minutes.
Five periods of time can be set to turn on the solar panel LED light. These periods can be set
with a min. of 0 and max. of 9 hours.
5.
Point the remote control at the solar panel’s black sensor and press
Transmit
to update the
solar panel with your new configuration. If you hear a long beep, the configuration settings are
transmitted succesfully.
