TBE-160CM Instruction Manual
Oct 2013 (USA)
12
S4 OPERATION
PREPARATION
ASSEMBLY
4.1
4.2
4.3
1. Inspect unit and all cables for damage before use.
2. Ensure the unit is dry.
3. Ensure the work environment is well ventilated and
away from any combustible substances.
4. Ensure that cables do not present a trip hazard.
5. If the items to be cleaned are small, place the parts in a
plastic container that can hold acidic fluids safely.
6. Parts will need to be sprayed with the recommended
Ensitech neutralizer or washed down with water after
cleaning. Ensure there is ready access to water and a
suitable place for washing.
7. Wear suitable personal protective equipment as
recommended in the MSDS. The minimum requirement
is for gloves to protect hands from the fluid, and goggles
to prevent fluid splashing into the eyes.
CLEANING FLUID
Pour a small quantity of the Cleaning Fluid into a shallow
bowl. Place the container close to the work because the tip
will be dipped into the fluid regularly during operation.
Refer to illustration on page 10.
1. Attach connector of black cable to black socket of
TIG Brush Unit.
2. Screw wand into handle.
3. Place shroud on brush and screw into wand.
4. Attach connector of red cable to red socket of
TIG Brush Unit to provide required operating mode.
Refer to section 5.
5. Attach power cord to mains outlet and TIG Brush Unit.
6. Attach clamp to workpiece.