Ensitech Pty Ltd
www.tigbrush.com
9
S2 SAFETY PRECAUTIONS
CAUTION
• Fluid spilled on the skin should be washed off as soon
as practical.
• Material Safety Data Sheet is available for all chemicals
and should be read before use.
• The brush gets extremely hot, around 392°F degrees
Fahrenheit. Be very careful touching the brush. Do not
place the brush near any flammable materials.
• The TIG Brush produces an electric current which may
generate small sparks between the brush and the metal
being cleaned.
• Hydrogen gas may also be generated (which is an
invisible but explosive gas). Always use the apparatus
in a well ventilated area. Do not use near flammable
substances, or in areas where dense flammable gases
(such as petrol vapor) may accumulate.
• The TIG Brush TBE-160CM uses 110V AC only. Do
not use with any other voltage. If the power cord is
damaged or if the TIG Brush has been dropped from a
height and damaged, do not use the unit. Contact your
TIG Brush supplier to have the TIG Brush inspected
and repaired.
• Do not short out the terminals, or use the TIG Brush with
a damaged wand or cables. Doing so may permanently
damage the TIG Brush and cause damage to the
workpiece being cleaned. The high currents involved
may also cause intense heating of the shorted or
damaged part, which could result in burns to
the operator.
• Ensure that the TIG Brush is located where it cannot
easily fall and cause injury. Ensure that the cables do
not present a trip hazard.
