18
TBE-250 Instruction Manual
Feb 2012
S8 TROUBLESHOOTING
ON/OFF SWITCH NOT ILLUMINATED
ON/OFF SWITCH ILLUMINATED & FRONT
PANEL POWER LIGHT NOT ILLUMINATED
•
Ensure the power switch is ON (with the “I” symbol on
the switch pressed in).
•
Ensure the power cable is pushed completely into the
socket on the side of the TIG Brush.
•
Ensure power is present at the power point (possibly by
plugging in another appliance, such as an
inspection light).
•
Check the fuse located below the mains socket. Using a
small screwdriver, place the tip in the indentation under
the plastic fuse drawer and pull out the drawer. If the
fuse at the end of the drawer is broken replace with a
fuse of the same specifi cation (8 amp, slow blow fuse,
size M205).
•
If the fuse blows again, contact your TIG Brush Supplier.
•
If the TIG Brush was being used prior to it turning off,
and the heat-sink at the back of the unit feels hot
(be careful as it may be very hot) the unit may have
over-heated. Wait 30 minutes for the unit to cool down
before trying to use it again. The unit can be cooled
more quickly by placing a damp cloth on the heat-sink.
8.1
8.2
If the TIG Brush is not operating correctly, please refer to the
following trouble shooting guide before contacting your TIG
Brush distributor.
3
Ensitech Pty Ltd
www.ensitech.com.au
INDICATES AN IMMEDIATELY HAZARDOUS SITUATION. IF NOT
AVOIDED, MAY RESULT IN MINOR OR MODERATE INJURY. IT
MAY ALSO ALERT AGAINST UNSAFE PRACTICES.
DANGER
THIS IS THE SAFETY ALERT SYMBOL. IT IS USED TO ALERT
YOU TO THE POTENTIAL PERSONAL INJURY HAZARDS. OBEY
ALL SAFETY MESSAGES THAT FOLLOW THIS SYMBOL TO
AVOID POSSIBLE INJURY.
WARNING
SYMBOL FOR “VOID WARRANTY” OR “DAMAGED WORK”
V
INDICATES AN IMMEDIATELY HAZARDOUS SITUATION. IF NOT
AVOIDED, MAY RESULT IN MINOR OR MODERATE INJURY. IT
MAY ALSO ALERT AGAINST UNSAFE PRACTICES.
CAUTION
FOREWORD
THIS SYMBOL INDICATES AN IMMEDIATELY HAZARDOUS
SITUATION WHICH SHOWS ENSITECH’S PROVISIONS FOR THE
MILD ACID. IF PRECAUTIONS ARE NOT TAKEN, MAY RESULT
IN MINOR OR MODERATE INJURY.
SAFETY ALERT SYMBOLS AND SAFETY SIGNAL WORDS