17
Installation instruction
for flat collectors on flat roof or foundation.
Inclination angle of an installation set can be adjusted by cutting the profile in a proper,
marked spot. Standard angles of inclination were set at 30, 45 and 60°.
When it is necessary to set the installation set in a different angle one should make
connection holes oneself, bearing in mind the maximum setting of the solar collector angle
in the range of 15 - 60°.
4.2.2 Setting the inclination angle of an installation set for a vertical collector
Inclination angle of an installation set can be adjusted
by means of telescopic rails. Standard inclination
angles have been determined as 30, 45 and 60°
depending on the position of the installation set. In
order to obtain the assumed inclination angle, it is
necessary to connect properly the sections of the
installation set.
30
o
angle is obtained by connecting the holes:
A1 with B1 and B2 with C1.
45
o
angle is obtained by connecting the holes:
A2 with B1 and B3 with C1.
60
o
angle is obtained by connecting the holes:
A2 with B1 and B4 with C1.
where:
A – Prop of supporting frame
B – Top strut
C – Bottom strut
When it is necessary to position the installation setat a different angle, connection holes
should be made by oneself, bearing in mind the maximum setting of the solar collector
angle in the range of 15 - 75°.
4.2.3. Inclination angle for n installation set for flat collectors on an economical triangle
(light version)
The construction allows setting the inclination angle only at 45
o
.
