23
Installation instruction
for flat collectors on flat roof or foundation.
4.10 Mounting a collector on a multi-slot section
Each collector should rest on two fastening holders to prevent them
from sliding down.
Fastening holders should be located at the distance of
x = 200-250mm from the collector’s edge.
4.11 Assembly of the fastening holders
The collector fastening holders should be assembled in the upper gap of the bottom multi-
slot section, according to the figure presented below
Fastening holder should be attached to the wider edge of the multi-slot section
4.12 Fastening the structure to the surface
After assembly, the supporting structure should be put in its place of destination.
The supporting structure should be fixed to the surface with anchor bolts to prevent it from
being torn out of the surface.
Via the holes in the foot of the supporting structure, the
places where the structure should be attached must be
marked.
After marking the holes:
- unbolt the foot of the supporting frame (the structure should
be put gently away, so that it does not interfere with work),
- make the anchor holes,
- attach the base to the surface,
- bolt the foot to the supporting frame.
