4
Installation instruction
for flat collectors on flat roof or foundation.
3. Before installation
Note
Due to the fact, that installation works on a roof can be dangerous it is recommended to hire
a roofing contractor company to carry them out.
BURN HAZARD
If collectors and installation materials are exposed to solar radiation for a long time, there is
a risk of getting burnt on the hot elements.
In order to avoid the danger of getting burnt it is appropriate to:
- use protective clothing,
- cover the collectors and installation elements with a tarpaulin (what limits the heat up
from the sun rays).
Caution!
If the collectors are packed on a transport pallet vertically,
use the following unloading instructions.
Read the instruction before proceeding to unloading of the vertical collector pallet!
1)
The first stage before unloading is to set the transport pallet on a flat surface. Figure 1.1 shows the transport
pallet set on a flat consolidated foundation
2)
The second stage of unloading is to put a 30mm high board under the transport pallet so that the inclined
transport pallet becomes stable. Figure 2.1 presents the conditions that the transport pallet should fulfill
before unloading.
3)
After fulfilling the conditions for setting the transport pallet, the collectors can be unloaded. Take special
caution while unloading
(COLLECTORS ARE PROTECTED ONLY AT THE FRONT OF THE
PALLET)
. In the picture marked as 3.1, the transport pallet ready for unloading is presented.
4)
After removing a collector, the next one should be
absolutely protected
until it is unloaded.
