Installation instruction
of the flat solar collectors models ES1V2.0, ES1V2.65,
ES2V/2.0 AL, ES2V/2.65
integrated in the slate roof.
escape it is necessary to close the ball valve.
4.3.3
Insulation work
Insulation work should be done after performing all inspection operations.
Directions!
−
High temperature and weather resistant insulation must be used to insulate
the conduits which are outside the building.
If necessary, protect the insulation against damage caused by birds.
−
High temperature resistant insulation must be used to insulate the conduits
inside the building.
4.4 Enclosure of the solar system
THE MONTER / INSTALLER MUST BE SURE OF A CORRECT
INSTALLATION AND LEAKPROOF OF THE COLLECTORS BEFORE
ENCLOSING THE SOLAR SYSTEM!
4.4.1 montage of the side flashing
4.4.2 Support frame for centre flashing
Affix both hook-in elements at the outer side of each
collector. Use four self-tapping screws (4,2 x 13mm)
for each element at the provided holes.
Clip in the support frame for the centre flashing
between the collectors (in the vertical centre).
