Installation instruction
of the flat solar collectors models ES1V2.0, ES1V2.65,
ES2V/2.0 AL, ES2V/2.65
integrated in the slate roof.
4.4.10 montage of the left top edge flashing
4.4.11 montage of the top edge flashing
4.4.12 montage of the right top edge flashing
Push together the top extension
flashing and the left top edge (approx.
40mm) and fix them outside the seam
with two wood screws (4 x 30mm).
Clip in the left top edge at the wind protection rail and fix
it at the wood wedge with two wood screws (4 x 30mm),
as shown on the small pictures. This has to be done
outside of the seam!
Fix the upper edge at the wood wedge by the help of a
coloured and sealed screw (4,5 x 35mm).
Fix the right upper edge at the wood wedge by the
help of a coloured and sealed screw (4,5 x 35mm).
Afterwards hook in four sheet strips along the upper
flashing and affix them with wood screws (4,5 x
35mm).
Stick the seal strip (20 x 20mm) across the total
width.
Wood screw 4 x 30mm
Wood screw 4 x 30mm
Coloured and sealed screw
The distance between the
flashing and the wind
protection rail should be
5mm!
Sheet strips
