Installation instruction
of the flat solar collectors models ES1V2.0, ES1V2.65,
ES2V/2.0 AL, ES2V/2.65
integrated in the slate roof.
3. Before commencing the installation.
D
irections!
As the work on the roof can be dangerous it is recommended to hire a
roofwork firm.
DANGER OF GETTING SCALED.
In case the collectors and assembly materials are exposed to solar radiation
for a long time, there is a risk of getting scalded by hot elements.
In order to avoid the danger of scalding you should:
use protective clothing,
cover the collectors and the assembly materials with canvas cover
(thanks to which the heating up by sunbeams will be reduced).
3.1 Transport and storage.
during transport the collector connectors are protected by rubber caps,
collectors should be stored in a dry place. In case the collectors are stored
outside they should be protected against weather conditions.
3.2 Technical Documentation
Solar installation set consists of different components. Before
installing any
of the components you should become
familiar with an adequate instruction.
A separate installation instruction is attached to a given device or a piece
equipment.
Installation instruction of solar collectors,
installation instruction of the pump group,
installation instruction of the solar controller,
installation instruction of the hot water container.
3.1 Completeness of delivery
Before commencing the installation it is necessary to check if the delivery is
complete and the delivered components are free of damage.
−
in case of discovering any damages the defected elements or parts should
be immediately replaced,
−
the replacement needs to be carried out with the application of original
spare parts only.
−
the basic set is designed for two solar collectors, extending the solar
instalation for each successive solar collector is associated with
purchase an aditional extension set for each solar collector
