Section 6 — Effect Parameters
Edit/Effects Parameters
3
DETUNE AMT
Range:
0 to 99
This parameter controls the depth of the detuning, that is, how much the pitch will change. Low
values yield a metallic sound. Some voices sound best with very low values.
PRE-DELAY TIME
ROOM and HALL REVERB Range: 0 to 500
44KHZ REVERB Range: 0 to 340
This parameter creates a delay in the amount of time it takes before the original signal is fed into
the reverb. The range is based in milliseconds.
ROM-04 DUAL DELAYS
ROM-05 44KHZ DELAYS
A professional quality stereo digital delay. DUAL DELAYS uses the standard 30KHZ (31 voice)
system sample rate, while 44KHZ DELAYS utilizes the 44KHZ system sample rate (polyphony is
reduced to 23 voices). Both algorithms have identical parameters. Both BUS1 and BUS2 can have
different Mix, Feedback, and Delay Time settings. BUS3 is dry.
BUS1 (and 2) DELAY MIX
Range:
0 to 99
This parameter controls the mix between the original signal and the delay. Setting this parameter
to 0 will allow only the unprocessed signal to be heard, while a setting of 99 will eliminate it
completely, with only the delay portion remaining.
BUS1 (and 2) FEEDBACK
Range:
0 to 99
Determines the amount of signal that will be fed from the output of the right delay back into the
input, increasing the number of repeats in the delay.
BUS1 (and 2) DELAY TIME
Dual Delays Bus1 Range: 0 to 2000
44 KHZ Delays Bus1 Range: 0 to 1300
Bus2 Range: 0 to 150
Determines the amount of the amount of time between delays. Each value increases the delay
time by 1 millisecond. The Left and Right channels are independently adjustable.
ROM-06 REVRB
This effect combines a four-voice chorus with the standard reverb. Assign a voice to BUS1 to get
both chorus and reverb, or use BUS2 for reverb only. Use BUS3 to bypass the effect (dry).
BUS1 REV AFTER CHOR
Range:
0 to 99
This parameter determines how much of the signal that is sent to BUS 1 (the chorus) will also go
to the reverb — it is a Reverb Mix for the chorused signal.
BUS2 REVERB MIX
Range:
0 to 99
This parameter controls the Dry/Wet mix of the Reverb for voices sent to BUS2.
REVERB DECAY TIME
HI FREQ BANDWIDTH
LOW FREQ DECAY
REVERB DETUNE RATE
DIFFUSION
REVERB DETUNE AMT
HI FREQ DAMPING
See the descriptions under HALL REVERB.
