Section 10 — Wave Data Parameters
ASR-10 Musician’s Manual
14
Command/Wave Page
• Pressing Enter•Yes from the QUALITY screen will execute the Command. The display will
read:
xx PERCENT DONE
CMD
STOP
WAVE
Range: 0 to 99
The xx value field counts up in real time. Pressing Cancel•No will abort the command.
If the selected WaveSample is a copy of another (or if there are copies of this WaveSample), the
following screen will appear:
COPIES WILL CHANGE-OK?
CMD
STOP
WAVE
• Pressing Enter•Yes will take you to the PERCENT DONE screen, as explained above.
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
CMD
COPY WAVE PARAMETERS
WAVE
Press Command / Wave / scroll using the arrow buttons
This command will copy all the WaveSample parameters (but not the wave data) from a source
WaveSample to a destination WaveSample. All the parameters (envelopes, filters, amp, pitch,
mod parameters, etc.) are copied from the source WaveSample to the destination WaveSample,
except for the actual sample pointers (sample start/end, loop start/end) and root key.
• Select COPY WAVE PARAMETERS. Press Enter•Yes.
• The display reads TO INST=## L=## WS=##. Select the destination instrument, layer, and
WaveSample. The current (or Edit) WaveSample is used as the source.
• Press Enter•Yes. The display reads COMMAND COMPLETED.
