Section 13 — Sequencer and Audio Track Parameters
Seq•Song Commands
7
CMD
ERASE SONG + ALL SEQS
SEQ•SONG
Press Command / Seq•Song / 7
Using this command clears all the sequencer memory. Save to disk all sequences that are
important to you before performing this command.
• Select ERASE SONG + ALL SEQS.
• Press Enter•Yes. The display reads ERASE ALL SEQ DATA?
• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).
CMD
APPEND SEQUENCE
SEQ•SONG
Press Command / Seq•Song / 8
This command allows a sequence to be attached (appended) to the end of another sequence. The
FROM SEQ= (source) will be attached to the end of the TO SEQ= (destination). You can also
append a sequence to itself to make a longer sequence. For example, if you have a drum
sequence that is four bars long, you could append it to itself to create an eight bar sequence. Do it
again and you have a sixteen bar sequence. The source sequence must have the same time
signature as the destination sequence.
• Select APPEND SEQUENCE.
• Press Enter•Yes. The display reads FROM SEQ=SEQUENCE ##. This is the source sequence.
Use the Up/Down Arrow buttons to select the source sequence.
• Press Enter•Yes. The display reads TO SEQ=SEQUENCE ##. This is the destination
sequence. Use the Up/Down Arrow buttons to select the destination sequence.
• Press Enter•Yes to complete the command. The source sequence will be attached to the end of
the destination sequence. Press Cancel•No to abort the procedure.
CMD
CHANGE SEQUENCE LENGTH
SEQ•SONG
Press Command / Seq•Song / 9
Use this command to add bars to or delete bars from a sequence.
• Select CHANGE SEQUENCE LENGTH.
• Press Enter•Yes. The display reads
ADD
## BARS AT ##.
If, for example, you wanted to add 2 bars to your sequence starting at bar 4, adjust the display
to look like this: ADD 2 BARS AT
4 .
• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).
• Or, you can underline
ADD
in the display and use the Up Arrow button to change it to
DELETE
. You can now delete specific bars from the sequence using the above procedure.
• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).
