Section 2 — System•MIDI
1
These pages contain parameters and commands that affect the ASR-10 as a whole.
Edit/System•MIDI Page
This page contains global system and MIDI parameters. Due to the large number of parameters
on this page, not all parameters have a direct dial number. Those that do will have that number
listed in its parameter illustration. Parameters without direct dial numbers can be accessed with
the Left/Right Arrow buttons.
Tip:
By double-clicking the System•MIDI button in Edit mode, you can toggle between the first
System Parameter and the first MIDI parameter.
Note:
The settings for most of these parameters will be saved to the O.S. disk when you perform the
SAVE GLOBAL PARAMETERS command (defined earlier).
System Parameters
EDIT
FREE SYSTEM BLOCKS
SYSTEM•MIDI
Press Edit / System•MIDI / 0
This page shows the amount of available internal memory (in blocks).
EDIT
FREE DISK BLOCKS
SYSTEM•MIDI
Press Edit / System•MIDI / scroll using the arrow buttons
This page shows the amount of available memory (in blocks) on the disk currently in the drive
(or on whatever SCSI Storage Device is selected as the storage device).
EDIT
MASTER TUNE
SYSTEM•MIDI
Press Edit / System•MIDI / 1
Adjusts the overall master tuning of the keyboard up or down as much as one semitone. A value
of +0 will set the ASR-10 to concert A=440 tuning.
Range: -99 to +99 cents
EDIT
GLOBAL BEND RANGE
SYSTEM•MIDI
Press Edit / System•MIDI / scroll using the arrow buttons
Use this parameter to adjust the pitch bend range. The bend range is adjustable in one-semitone
increments from 0 to 12. Each ASR-10 WaveSample can have its own bend range (which will
override the global bend range) or can use this global bend range.
Range: 0 to 12 semitones
Note:
When MASTERTUNE and GLOBAL BEND RANGE are edited, the ASR-10 will transmit the
current value as a Registered Parameter Select message, on the MIDI BASE CHANNEL.
