Section 2 — System•MIDI
Edit/System•MIDI Parameters
3
EDIT
LEFT FOOT SW
SYSTEM•MIDI
Press Edit / System•MIDI / scroll using the arrow buttons
When the optional SW-10 Dual Foot Switch is plugged into the rear panel Foot Switch jack, this
page allows the Left Foot Switch to perform a variety of assignable functions. The Right Foot
Switch is permanently dedicated to function as the Sustain pedal.
• OFF — This setting makes the ASR-10 ignore the Left Foot Switch. If you are using the single
foot switch (SW-2) which came with the ASR-10, then you should keep this parameter set to
OFF (the SW-2 will only function as a sustain pedal).
• FX MODSRC — This setting allows the left foot switch to function as an effects modulation
source, assignable to any modulation destination in any effect.
• SAMPL YES — This setting allows you to initiate sampling with the Left Foot Switch. After
pressing the Sample•Source Select button, successive presses of the Left Foot Switch will
behave as though the Enter•Yes button has been pressed.
• STOP/CONT — When set to STOP/CONT, the left pedal of the SW-10 duplicates the action of
the Stop•Continue button. When in standby record, pressing the Left Foot Switch will
initiate recording.
Note:
If you are using a single foot switch (SW-2 or SW-6), this parameter should be set to OFF to
prevent unexpected behaviour.
Note:
If you want the SW-10 to duplicate the behavior of the Patch Select buttons, plug it into the Patch
Select jack located on the rear panel. The Patch Select jack requires a dual foot switch and will not
work properly with a single foot switch (SW-2 or SW-6).
EDIT
AUTO-LOOP FINDING (ON/OFF)
SYSTEM•MIDI
Press Edit / System•MIDI / 3
This parameter enables or disables the “Expert-System” auto-loop function. If the auto-loop
function is enabled, the ASR-10 will automatically go to zero crossings (with matching wave
direction) whenever you move the loop start or end pointer. This is a very useful feature because
finding zero crossings is essential to creating glitch-free loops. If the auto-loop function is
disabled, the loop start and end parameters will move in one-sample increments.
Note:
AUTO-LOOP FINDING will not function on a WaveSample that exists in a stereo layer (i.e. a
layer in which STEREO LAYER LINK = ON).
