UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
ENSTROM F-28F/280F SERIES MAINTENANCE MANUAL SUPPLEMENT 1
Rev.
7
10-5
Aug
28/17
C. Remove the cable tie or other similar device from the
COM
and
NAV
circuit breaker stems
and push the stems in to set the circuit breakers.
4-1-4. Functional
Check
A. If the installation is a replacement, configure the GNC 255A in accordance with the
configuration pages in Figure 10-2 and perform the post installation checkout in
accordance with section 6 of the GTR 225/GNC 255 Installation Manual (para. 1-2).
4-1-5. Software
Update
A. Verify the software version number matches the approved software version listed in
Enstrom Rotorcraft Flight Manual Supplement 28-AC-074. The software version will
appear on the start up screen after power up. If the replaced unit does not have the
approved version of software installed, software can be downloaded from the Garmin
Dealer Resource Center at
www.flyGarmin.com
.
4-2.
Figures and Electrical Diagrams
A. The GNC 255A installation is shown in Figure 10-1.
B. The GNC 255A configuration set-up pages are shown in Figure 10-2.
C. The GNC 255A wiring interface is shown in Diagram 10-1.
Visit www.enstromhelicopter.com for instructions to order an original manual and to register for email notification of updates.