UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
ENSTROM F-28F/280F SERIES MAINTENANCE MANUAL SUPPLEMENT 1
1-5
Nov
18/08
4-2.
Wiring Harnesses/Connectors – SL30
4-2-1. Removal – Wiring Harnesses/Connectors – SL30
CAUTION
Before removing or adjusting any electrical component,
ensure all electrical power is off and the battery is
disconnected.
A. Refer to Diagram 1-1 for the SL30 wiring interface.
B. Remove the attaching hardware, clamps, connectors, leads, or wiring.
C. Identify the connectors, leads, or wiring.
D. Remove the component.
4-2-2. Inspection – Wiring Harnesses/Connectors – SL30
A. Inspect the plugs, connectors and receptacles for security, contact corrosion,
damaged contacts, broken wires, faulty contacts, insert cracks, and faulty insulation.
B. Inspect the leads and wiring for loose terminals, chafing, corrosion or
deteriorated condition, faulty or damaged insulation, excessive mechanical stress, broken
strands, damaged shielding, shorted shielding, routing and mounting conditions.
4-2-3. Repair – Wiring Harnesses/Connectors – SL30
A. Tighten lose terminal connectors, mounting hardware, and electrical
component attachments.
B. Replace miscellaneous electrical components that fail to meet the inspection
requirements.
C. Clean corrosion from the connections and receptacles with contact cleaner.
4-2-4. Installation – Wiring Harnesses/Connectors – SL30
A. Refer to Diagram 1-1 for the SL30 wiring interface.
B. Install the electrical component and secure with attaching hardware, clamps,
or cable ties.
Visit www.enstromhelicopter.com for instructions to order an original manual and to register for email notification of updates.
