PREPARING YOUR RADIO FOR USE
Attaching / removing the antenna
1.
To attach, carefully align the antenna with the
socket. Screw in the antenna clockwise (taking
care not to cross the thread) until it is seated
firmly with the accessory cover’s rubber ring
between the antenna and the top of the radio
(A)
.
2.
To remove, unscrew the antenna anti-clockwise
(B)
.
4.
Adjust the volume control (1) to select the
desired volume level.
5.
Using the channel control (2), ensure you have
the correct channel selected.
6.
When receiving a valid signal, the LED will
illuminate steady green and audio will be emitted
from the radio’s speaker or audio accessory (if
attached).
7.
When finished using the radio, switch off by
turning the on/off/volume control (1) counter
clockwise until it clicks and the radio will be
switched off.
TRANSMITTING
1.
Perform steps 1 through to 5 above.
2.
Before transmitting, monitor the channel and
make sure it is clear.
3.
When receiving a signal, wait until the signal
stops before transmitting. The radio cannot
transmit and receive simultaneously.
4.
Press the Push-To-Talk (PTT) button (4) to begin
your transmission. To confirm transmission the
LED will illuminate red.
5.
For best transmitted speech quality, you must
talk directly into the radio’s microphone (8) at
around 4cm between your mouth and the radio.
6.
Please note: if you talk into the top of the radio
or with your mouth further away, you will transmit
poor quality speech.
7.
When the transmission is finished release the
PTT button.
Attaching / removing the battery pack
1.
To attach
(C)
, locate the pegs on the bottom of
the battery into the slots on the radio and pull
the 2 latches downwards, carefully pushing
the battery into the radio. Release the latches
ensuring the battery is full attached.
2.
To remove
(D)
, pull down the 2 latches and
carefully pull the battery away from radio.
SWITCHING ON, RECEPTION AND
SWITCHING OFF
1.
To switch on rotate the on/off/volume control (1)
on the top of the radio clockwise, you will hear a
click from the control.
2.
When the radio has passed its diagnostic tests, it
will emit a fanfare tone.
3.
The radio will enter standby mode. This is
indicated by the LED flashing amber once every
5 seconds, signaling that the radio is ready for
use.
CONTACT
For more information about our products, please contact us:
+44 (0)20 8236 0032 info@entel.co.uk entel.co.uk
All Rights Reserved. Copyright Entel UK Ltd.
For a detailed specification on all products listed please visit our webpage - entel.co.uk
A
B
C
D
