Command Line Interface
4-10
4
line
Use this command to identify a specific line for configuration, and to process
subsequent line configuration commands.
Syntax
line
{
console
|
vty
}
•
console
- Console terminal line.
•
vty
- Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration
Command Usage
Telnet is considered a virtual terminal connection and will be shown as “Vty” in
screen displays such as
show users
. However, the serial communication
parameters (e.g., databits) do not affect Telnet connections.
Example
To enter console line mode, enter the following command:
Related Commands
show line (4-18)
show users (4-63)
silent-time*
Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the
password-thresh
command
LC
4-15
databits*
Sets the number of data bits per character that are interpreted and
generated by hardware
LC
4-15
parity*
Defines the generation of a parity bit
LC
4-16
speed*
Sets the terminal baud rate
LC
4-17
stopbits*
Sets the number of the stop bits transmitted per byte
LC
4-17
disconnect
Terminates a line connection
PE
4-18
show line
Displays a terminal line's parameters
NE, PE 4-18
* These commands only apply to the serial port.
Console(config)#line console
Console(config-line)#
Table 4-5. Line Command Syntax
(Continued)
Command
Function
Mode
Page
Summary of Contents for Matrix-V V2H124-24P
