Enterasys S-Series S8 Chassis Hardware Installation Guide 3-1
3
Chassis Setup
This
chapter
contains
instructions
on
setting
up
the
S8
chassis.
Required Tools
•
ESD
wrist
strap
(included
with
the
S8
chassis)
•
Phillips
screwdriver
•
Flat
blade
screwdriver
A
Phillips
screwdriver
is
needed
to
install
the
unit
in
a
48.26
‐
centimeter
(19
‐
inch)
equipment
rack.
A
flat
blade
screwdriver
is
needed
to
secure
the
power
supplies
and
to
remove
and
reinstall
the
Electrical Hazard:
Only qualified personnel should perform installation procedures.
Riesgo Electrico:
Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis:
Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
For information about...
Refer to page...
Attaching the Electrostatic Discharge Wrist Strap
Installing and Removing an S-AC-PS Power Supply
Removing and Installing a Fan Tray
Installing and Removing an S-POE-PS Power Supply
Connecting Power to the S-POE-PS Power Supplies
Connecting to the COM Port for Local Management
Important Notice
Read the Release Notes specific to the firmware image running in the chassis to check for any
exceptions to the supported features and operation documented in this guide.
Summary of Contents for S4-Chassis
