Installing and Removing an S-POE-PS Power Supply
3-22 Chassis Setup
Installing the S-POE-PS Power Supplies in the PoE Subsystem
The
PoE
subsystem
must
be
installed
on
the
S8
chassis
before
installing
the
S
‐
POE
‐
PS
power
supplies
in
the
PoE
subsystem.
For
information
on
upgrading
an
S8
chassis
with
a
PoE
subsystem,
see
the
Enterasys
S
‐
Series
PoE
Subsystem
Upgrade
Installation
Guide
.
To
install
the
S
‐
POE
‐
PS
power
supplies
in
the
PoE
subsystem:
1.
Open
the
ejection
handle
faceplate
of
the
S
‐
POE
‐
PS
power
supply
by
releasing
the
spring
clip
on
the
lower
left
of
the
faceplate.
2.
Align
the
power
supply
with
bay
1
(labeled
PS1),
then
slide
the
S
‐
POE
‐
PS
power
supply
forward
until
the
S
‐
POE
‐
PS
power
supply
is
plugged
into
the
subsystem
connector
and
is
completely
inside
the
bay.
See
The
power
supply’s
faceplate
will
close
as
the
power
supply
plugs
into
the
subsystem
connector.
If
you
encounter
significant
resistance
before
the
S
‐
POE
‐
PS
power
supply
reaches
the
end
of
its
travel,
remove
and
reinsert
the
power
supply.
Figure 3-15 Inserting the S-POE-PS Power Supply in the PoE Subsystem
3.
Close
the
power
supply’s
faceplate
completely
against
the
spring
clip
on
the
power
supply.
Summary of Contents for S4-Chassis
