Installing and Removing an S-POE-PS Power Supply
Enterasys S-Series S8 Chassis Hardware Installation Guide 3-21
Installing and Removing an S-POE-PS Power Supply
If
your
S8
chassis
is
equipped
with
a
PoE
subsystem,
you
must
install
S
‐
POE
‐
PS
power
supplies
to
provide
PoE
power
to
the
powered
devices
(PDs)
attached
to
the
10/100/1000
Mbps
RJ45
ports
in
the
installed
S
‐
Series
I/O
modules.
Unpacking the S-POE-PS Power Supplies
The
S
‐
POE
‐
PS
power
supply
modules
are
shipped
in
boxes
separate
from
the
S
‐
Series
chassis.
To
unpack
a
power
supply:
1.
Unpack
the
power
supply
by
removing
it
from
the
shipping
box
and
sliding
the
two
foam
end
caps
off
the
unit.
Save
the
shipping
box
and
materials
in
the
event
the
unit
must
be
reshipped.
2.
Verify
the
contents
of
the
box
using
as
appropriate.
3.
Remove
the
power
supply
from
its
protective
plastic
bag.
4.
Examine
the
power
supply
carefully,
checking
for
damage.
If
there
are
any
signs
of
damage,
DO
NOT
install
the
power
supply;
instead,
contact
Enterasys
Networks.
Refer
to
for
details.
Note:
You must order S-POE-PS power supplies separately.
Table 3-3 Contents of S-POE-PS Power Supply Carton
Item
Quantity
S-POE-PS power supply
1
For USA shipments: NEMA Power Cord 6-20, C19, R/A, SHLD
Type of power cord is dependent on country of installation.
1
NOTICE Card
1
Summary of Contents for S4-Chassis
