Completing the Installation
Enterasys S-Series S8 Chassis Hardware Installation Guide 3-31
Completing the Installation
After
installing
the
S8
chassis
and
making
the
connections
to
the
network,
access
the
device
management
startup
screen
from
your
PC
or
terminal
connection
as
described
in
the
following
section.
Start
the
Command
Line
Interface
(CLI)
from
the
device’s
local
console
port
as
follows:
1.
Connect
a
terminal
to
the
local
console
port
as
described
in
28.
The
startup
screen
displays.
2.
At
the
login
prompt,
enter
one
of
the
following
default
user
names:
–
ro
for
Read
‐
Only
access
–
rw
for
Read
‐
Write
access
–
admin
for
Super
User
access.
(This
access
level
allows
Read
‐
Write
access
to
all
modifiable
parameters,
including
user
accounts.)
3.
Press
Enter
.
4.
The
Password
prompt
displays.
Leave
this
string
blank
and
press
Enter
.
The
device
information
and
SSA
prompt
displays
as
shown
in
.
The
S8
chassis
is
now
ready
to
be
configured.
For
information
about
setting
the
IP
address
and
configuring
Telnet
settings
for
remote
access
to
S8
chassis
management,
refer
to
the
Enterasys
S
‐
Series
Configuration
Guide
.
The
CLI
commands
enable
you
to
initially
set
up
and
perform
more
involved
management
configurations.
The
Enterasys
S
‐
Series
Configuration
Guide
is
available
online
at:
http://www.enterasys.com/support/manuals
Note:
This procedure applies only to initial log-in and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the S8 chassis is configured with three user login accounts:
ro
for Read-Only
access;
rw
for Read-Write access; and
admin
for super-user access to all modifiable
parameters. The default password is set to blank (carriage return). For information on
changing these default passwords, refer to the
Enterasys S-Series Configuration Guide
.
login:
admin
Password:
S8
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2009
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
S Chassis Chassis(su)->
Summary of Contents for S4-Chassis
