Installing the Switch on a Flat Surface
3-6 Hardware Installation
Installing the Rubber Feet
To
install
the
rubber
feet,
refer
to
Figure 3
‐
5
and
proceed
as
follows:
1.
Place
the
switch
on
its
back
on
a
sturdy
flat
surface
to
gain
access
to
the
bottom
of
the
chassis.
2.
Remove
the
four
rubber
feet
from
their
plastic
bag
in
the
shipping
box.
3.
Locate
the
four
marked
locations
on
the
bottom
four
corners
of
the
chassis.
Figure 3-5 Chassis Bottom, Rubber Feet Placement
4.
Remove
the
protective
strip
from
the
back
of
one
rubber
foot
and
position
it
on
a
marked
location
and
press
firmly
into
place.
Repeat
this
procedure
to
install
the
remaining
three
rubber
feet.
5.
After
installing
the
rubber
feet,
return
the
switch
to
its
upright
position.
1
Bottom of chassis as seen when chassis is
resting on its back
3
Rubber feet with adhesive backing
(four)
2
Locations to install the rubber feet (four locations)
Note:
If a number of switches are being installed in a stack, repeat steps 1 through 4 to
install the rubber feet on each switch before continuing with the installation.
À
Á
Â
Â
Â
Â
Summary of Contents for SecureStack B2 B2G124-48P
