Using the Reset Switch
4-8 Troubleshooting
Using the Reset Switch
If
you
forget
the
switch
login
password,
use
the
Reset
switch
to
reset
the
login
password
to
the
default
password,
as
described
in
the
following
procedure.
Figure 4-3 Reset Switch
Port(s) goes into
standby for no
apparent reason.
Loop condition detected.
Verify that Spanning Tree is enabled. Refer to the
SecureStack C3 Configuration Guide
for the instructions to
set the type of STA.
Review the network design and delete unnecessary loops.
If the problem continues, contact Enterasys Networks for
technical support.
User parameters
(IP address, device
and module name,
etc.) were lost
when the switch
power was cycled.
Clear NVRAM was set using
CLI commands.
Reenter the lost parameters as necessary. Refer to the
SecureStack C3 Configuration Guide
for the instructions to
configure the switch using CLI commands.
If the problem continues, contact Enterasys Networks for
technical support.
Table 4-2 Troubleshooting Checklist (continued)
Problem
Possible Cause
Recommended Action
1
Reset switch
STACK UP
STACK DO
WN
À
Summary of Contents for SecureStack B3G124-24P
Page 2: ......
Page 14: ...xii...
Page 68: ...Using the Reset Switch 4 10 Troubleshooting...
