Chapter 2: Installation
2-10
VHSIM-G6 User’s Guide
Figure 2-6
GPIM-09 Launch Mode Conditioning Cable Connection
2.
Once the Launch Mode Conditioning cable is connected to the ends of
the multimode fiber cable, proceed to
Section 2.4.2
to complete the
installation to the GPIM-09 device.
2.4.2
VHSIM-G6 Network Connection
To connect the VHSIM-G6 using fiber cable to the network, perform the
following steps:
1.
Remove the protective covers from the fiber optic ports and from the
ends of the connectors.
NOTE
If connecting the VHSIM-G6 with a GPIM-09 to the network
using multimode fiber cable, refer to
Section 2.4.1
before
following this procedure.
!
CAUTION
The GPIM-01 and GPIM-09 use Class 1 lasers. Do not use
optical instruments to view the laser output. The use of optical
instruments to view laser output increases eye hazard. When
viewing the output optical port, power must be removed from
the network adapter.
Installed multimode
fiber cable
Long Wavelength
Gigabit Fiber Device
Launch Mode
Conditioning
Cable
Launch Mode
Conditioning
Cable
Long Wavelength
Gigabit Fiber Device
mmfLWct
Connect the ends of the
multimode cable to the
Launch Mode Conditioning
Cable
Summary of Contents for VHSIM-G6
